Nortel Millennium M1000 Manual page 103

rprbk203 Page 35 Tuesday, February 16, 1999 9:12 AM
To connect the cables which make up the smart card alert
feature to a multi-application control PCP, follow this proce-
dure:
1. This procedure assumes you have followed the direc-
tions in Preparing the terminal for maintenance on
page 2-3 and Opening and closing the terminal on
page 2-6, including:
Upload • Upload the CDRs to the Millenni-
um Manager before you replace
CDRs
components.
• attached your ESD wrist strap to the ESD connec-
tion point inside the terminal
• disconnected the terminal block from the rear ter-
minal PCP to disconnect the power
Electrostatic • Connect your ESD wrist strap
discharge
• Disconnect the power.
(ESD)
• Do not reconnect the power
Failure to follow these
procedures may damage the
electrostatic-sensitive devices.
2. Connect the cable from the alerter module to J3 on the
control PCP.
3. Connect the 4-pin connector of the smart card alert in-
terconnect cable, shown in Figure 3-20, to the J2 con-
nector on the control PCP.
This cable will have a three-pin connection to either
the keypad PCP (refer to Figure 3-21) or the external
interface hookswitch module (refer to Figure 3-22), de-
pending on the configuration of keypad/hookswitch in
the terminal.
Millennium Multi-pay-based terminals: replacing parts
PCP assembly components 3-35
inside the terminal.
until you are ready to close the
terminal.