Nortel Millennium M1000 Manual page 88

rprbk203 Page 20 Tuesday, February 16, 1999 9:12 AM
3-20 PCP assembly components
Figure 3-10: Control PCP showing SAM sockets
SAM
sockets
on
removable
SAM daughter
board
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
Electrostatic • Connect your ESD wrist strap
discharge
(ESD)
• Disconnect the power: Re-
• Do not reconnect the power
Failure to follow these
procedures may damage the
electrostatic-sensitive boards.
Refer to Figure 3-10 to locate the SAM sockets.
2. Unlock the SAM socket by sliding the plastic lock tab
toward the body of the unit.
Warning
If the power is not disconnected by
this point, the control PCP and/or
the SAM will be damaged when the
SAM is installed or removed.
to the ESD connection points
inside the terminal.
move terminal block from rear
terminal PCP.
until you are ready to close
the terminal.