Nortel Millennium M1000 Manual page 212

rprbk203 Page 30 Tuesday, February 16, 1999 9:12 AM
6-30 Coin path modules
Figure 6-26: Removing the coin box rail
Coin box rail
assembly
(upper
view)
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
b) Remove the escrow as explained in Replacing
the coin escrow on page 6-15 and put it aside in
an anti-static bag
See this Newer versions of terminal hard-
ware may not require the removal
of the validator and escrow to
access the screws. In that case,
skip step 2.
3. Enter the coin vault as described in Replacing the
vault door or the coin box on page 6-25.
4. Inside the rear housing:
a) Disconnect the vault security cable (J31) from the
rear terminal PCP (J30).
b) Remove the two screws holding the coin box rail to
the vault top.
Refer to Figure 6-26 to locate screw positions.
Coin box
rail
(installed)
Coin vault
Two screws
attach
from above
Screw
attaches
from below