Nortel Millennium M1000 Manual page 198

rprbk203 Page 16 Tuesday, February 16, 1999 9:12 AM
6-16 Coin path modules
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
To remove the escrow for replacement or to clear a coin
jam, do the following:
1. This procedure assumes you have followed the direc-
tions in Preparing the terminal for maintenance on
page 2-3 and Opening and closing the terminal on
page 2-6, including:
Upload
• Be sure you upload CDRs before
you do this procedure.
CDRs
before you
start
• attached your ESD wrist strap inside the terminal
• confirmed the power is disconnected at the rear
terminal PCP
• removed the coin validator as explained in
Replacing the coin validator on page 6-6
Electrostatic • Before working with the inter-
discharge
(ESD)
• Place any components you re-
Warning • Disconnect the power before
• Do not reconnect the power
Failure to follow these precautions may damage
the ESD-sensitive components of the PCPs.
nal boards, put on your ESD
wrist strap and connect it to an
ESD connection point inside
the terminal.
move from the terminal into an
anti-static bag or onto an anti-
static surface.
disconnecting any other ca-
bles.
until you are ready to close
the terminal.