Table of Contents
Advertisement
rprbk203 Page 20 Tuesday, February 16, 1999 9:12 AM
6-20 Coin path modules
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
9. Restore the terminal to operation.
Refer to Restoring the terminal to operation on
page 2-10, if necessary.
a) Reconnect the power to the terminal by recon-
necting the terminal block to the rear terminal PCP.
b) Remove your ESD strap connection.
c) Close and lock the terminal.
d) If you replaced the module with a new one,
perform the INSTALL routine to store coin data in
the terminal memory.
e) If you replaced the same module after clearing it,
go into the craft interface and perform the coin test
several times to confirm that the coin path is clear.
If any of the coin tests fail, replace the escrow.
10. Perform function tests once the terminal is back in op-
eration.
Advertisement
Table of Contents
