Table of Contents
Advertisement
rprbk203 Page 30 Tuesday, February 16, 1999 9:12 AM
5-30 Card and hookswitch parts
Figure 5-28: Hookswitch PCP screws
Hookswitch
PCP
Securing
screws
for
hookswitch
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
3. Loosen the two M3.5 tapping screws securing the
hookswitch PCP assembly.
•
This allows the hookswitch PCP to be lifted over
the locating pin.
•
Use a #2 type 1A cross-recess screwdriver.
•
Figure 5-28 shows these screws.
4. Slide the hookswitch PCP assembly until the slots on
the module clear the screw heads.
5. Remove the hookswitch PCP assembly.
6. Install the new assembly:
Module A: Reverse the preceding steps.
•
Take care not to damage the switch actuator on
the plunger cam. Refer to Figure 5-30.
•
To ensure the switch actuator is not damaged
while you are installing it, depress the plunger
while assembling the hookswitch module into posi-
tion.
Module B:
a) Install the rain shield:
Set the hookswitch rain shield in the recess in the
terminal housing located under the assembly, as
shown in Figure 5-29.
Keypad PCP
Top of
front
housing
Advertisement
Table of Contents
