Nortel Millennium M1000 Manual page 117

rprbk203 Page 11 Tuesday, February 16, 1999 9:12 AM
Figure 4-9: Graphical display and ID bezel screws
Top of front
housing
e) Grasp the assembly at the top and bottom and lift
up the right side to about 45 degrees. Refer to
Figure 4-10.
Note: The assembly sits under the lock and swivel.
To remove or replace it, angle the assembly so it
slides under these components.
f) Pull the assembly out of the terminal.
Millennium Multi-pay-based terminals: replacing parts
Upper bezel components 4-11
Lower
display
assembly
screws
Display
assembly
ID bezel
screws
(upper
display
assembly
screws)