Table of Contents
Advertisement
rprbk203 Page 6 Tuesday, February 16, 1999 9:12 AM
3-6 PCP assembly components
Table 3-1: Component connections list
Disconnect these components
Remove this cable first; reconnect this cable last.
J18, rear terminal PCP
J15, handset
J53, keypad PCP
J53, alerter module *
J19, card reader PCP
J20, display PCP
If the terminal is equipped with a datajack module:
J35, datajack module
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
Electrostatic
• Before working with the PCP
discharge
(ESD)
• Disconnect the supplementa-
• Do not reconnect the pow-
Failure to follow
these precautions
• Place any components you
may damage
the ESD-sensitive
components of
the PCPs
2. Disconnect the cables from the telephony and control
PCPs, folding them back out of the way.
Table 3-1 lists the cable numbers and connector num-
bers for cables which connect to the telephony or con-
trol PCP.
from:
J5 on the control PCP
J10B on the telephony PCP
J1A on the telephony PCP
J6 on the control PCP
J7 on the control PCP
J34 on the telephony PCP
assembly, put on your ESD
wrist strap and connect it to
the ESD connection points
shown in Figure 7-2.
ry power supply.
er until you are ready to
close the terminal.
remove from the terminal into
an anti-static bag or onto an
anti-static surface.
Advertisement
Table of Contents
