Nortel Millennium M1000 Manual page 146

rprbk203 Page 4 Tuesday, February 16, 1999 9:12 AM
5-4 Card and hookswitch parts
Figure 5-3: Card reader connector on control PCP
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
ESD
precautions
Failure to follow
these precautions
may damage ESD-
sensitive
components.
2. Terminals with multi-card readers only: Remove
the PCP assembly as explained in Removing the
PCP assembly on page 3-2, place in an anti-static
bag and set aside.
3. Disconnect the card reader connector (J19) from the
control PCP connector (J6), if you did not remove the
PCP assembly.
4. If the card reader has a rain shield, remove this now.
Rotate the top of the rain shield down and away from
the card reader and gently pull it free.
• Before working with the
PCP assembly, put on your
ESD wrist strap and connect
it to the ESD connection
points.
• Disconnect the power.
• Do not reconnect until you
are ready to close the ter-
minal.
• Place any components you
remove from the terminal
into an anti-static bag.
Card
reader
connector
on control
PCP