Nortel Millennium M1000 Manual page 139

rprbk203 Page 33 Tuesday, February 16, 1999 9:12 AM
Figure 4-29: Locating ID bezel screws
Remove these ID bezel screws
Figure 4-30: Removing the clamp plate
3. On the inside of the terminal, remove the two screws
holding the ID bezel in place. Refer to Figure 4-29.
4. From the front of the housing, remove the ID bezel.
5. On the inside of the terminal, remove the clamp plate
and attached VFD assembly, shown in Figure 4-30.
Millennium Multi-pay-based terminals: replacing parts
Upper bezel components 4-33
Clamp plate
Top of front housing
Keypad PCP
VFD assembly
Clamp plate
Top of
front housing