Digi Connect IT 4 User Manual page 575

Services
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Service Discovery (mDNS).
4. The mDNS service is enabled by default. To disable, click to toggle off Enable.
5. Click Access control list to configure access control:
To limit access to specified IPv4 addresses and networks:
n
a. Click IPv4 Addresses.
b. For Add Address, click .
c. For Address, enter the IPv4 address or network that can access the device's mDNS
d. Click  again to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
a. Click IPv6 Addresses.
b. For Add Address, click .
c. For Address, enter the IPv6 address or network that can access the device's mDNS
d. Click  again to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the Connect IT 4
n
device:
Digi Connect IT® 4 User Guide
service. Allowed values are:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the mDNS service.
l
service. Allowed values are:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the mDNS service.
l
Enable service discovery (mDNS)
Use Digi Remote Manager to view and manage your
575