Digi Connect IT 4 User Manual page 414

Virtual Private Networks (VPN)
(config network interface gre_interface)> ipv4 address 10.10.1.1/24
(config network interface gre_interface)>
7. Save the configuration and apply the change:
(config network interface gre_interface)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Task Two: Configure the GRE tunnel

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click VPN > IP Tunnels.
4. For Add IP tunnel, type a name for the GRE tunnel and click .
5. Enable the tunnel.
New tunnels are enabled by default. To disable, toggle off Enable.
6. For Mode, select either:
GRE: Standard GRE point-to-point protocol.
n
mGRE: multipoint GRE protocol.
n
7. For Local endpoint, select the GRE endpoint interface created in
Digi Connect IT® 4 User Guide
Generic Routing Encapsulation (GRE)
Use Digi Remote Manager to view and manage your
Task One.
414