Digi Connect IT 4 User Manual page 572

Services
c. For Device, select the Ethernet bond created above:
d. Complete the rest of the interface configuration. See
(WAN) or
e. Disable any other interfaces associated with the devices that were added to the Ethernet
bond.
For example, if WAN and LAN were added to the Ethernet bond, disable the WAN and LAN
interfaces:
In some cases, the device may be a part of a bridge, in which case you should remove the
device from the bridge.
See Configure a bridge
9. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a network bond:
(config)> add network bond name
(config network bond name)>
Digi Connect IT® 4 User Guide
Configure a Local Area Network (LAN)
for more information.
Ethernet network bonding
Configure a Wide Area Network
for further information.
572