Digi Connect IT 4 User Manual page 246

Serial port
n
Digi Connect IT® 4 User Guide
(config)> add serial port1 udp acl interface end value
(config)>
Where value is an interface defined on your device.
Display a list of available interfaces:
Use ... network interface ? to display interface information:
(config)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip
defaultlinklocal
lan
loopback
modem
wan
(config)>
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
(config)> add serial port1 udp acl zone end value
(config)>
Where value is a firewall zone defined on your device, or the any keyword.
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can
be referred to by packet
filtering rules and access control lists.
Additional Configuration
------------------------------------------------------
-------------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
Configure UDP serial mode
Default IP
Default Link-local IP
LAN
Loopback
Modem
WAN
246