Add An Authentication Group - Digi Connect IT 4 User Manual

User authentication
To enable Shell access for the serial group:
l
Shell access is not available if the Allow shell parameter has been disabled. See
Disable shell access
Serial access:
n
To enable Serial access for the admin group:
l
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Add an authentication group

Required configuration items
The access rights to be assigned to users that are assigned to this group.
n
Additional configuration items
The serial ports that the user can access.
n
Access rights to OpenVPN tunnels, and the tunnels to which they have access.
n
Access rights to captive portals, and the portals to which they have access.
n
Access rights to query the device for Nagios monitoring.
n
To add an authentication group:

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Digi Connect IT® 4 User Guide
(config)> auth group serial acl shell enable true
(config)>
for more information about the Allow shell parameter.
(config)> auth group admin acl serial enable true
(config)>
Use Digi Remote Manager to view and manage your
Authentication groups
660