Services
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config service multicast test)> src_interface
b. Set the interface. For example:
(config service multicast test)> src_interface /network/interface/wan
(config service multicast test)>
7. Set a destination interface that the Connect IT 4 device will send mutlicast packets to:
a. Use the ? to determine available interfaces:
(config service multicast test)> src_interface ?
Destination interface: Which interface to send the multicast packets.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config service multicast test)> src_interface
b. Set the interface. For example:
(config service multicast test)> add interface end
/network/interface/wan
(config service multicast test)>
c. Repeat for each additional destination interface.
8. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Digi Connect IT® 4 User Guide
Configure a multicast route
569