Digi Connect IT 4 User Manual page 103

Interfaces
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Modems > Modem.
4. Modem are enabled by default. Click to toggle Enable to off to disable.
5. For Active SIM slot, select the SIM slot that should be used by the modem, or select Any to
use any SIM slot. The default is Any.
6. If Active SIM slot is set to Any, for Preferred SIM slot, select the SIM slot that should be
considered the preferred slot for this modem, or select None. In the event of a failover to a
non-preferred SIM, or if manual SIM switching is used to switch to a non-preferred SIM, the
modem will attempt to reconnect to the SIM in the preferred SIM slot. None is the default.
7. For Maximum number of interfaces, type the number of interfaces that can be configured to
use this modem. This is used when using
8. For Signal strength query interval, type or select the amount of time the system waits
before polling the modem for signal information.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Signal strength query interval to ten minutes, enter 10m or 600s.
The default is 30s.
9. Enable Carrier switching to allow the modem to automatically match the carrier for the active
SIM. Carrier switching is enabled by default.
Digi Connect IT® 4 User Guide
Use Digi Remote Manager to view and manage your
dual-APN SIMs. The default is 1.
Wide Area Networks (WANs)
103