Digi Connect IT 4 User Manual page 690

Hide thumbs Also See for Connect IT 4:

Table of Contents

User authentication

8. Add RADIUS to the authentication methods:

a. Click Authentication > Methods.

b. For Add method, click .

c. Select RADIUS for the new method from the Method drop-down.

Authentication methods are attempted in the order they are listed until an authentication

response, either pass or fail, is received. If Authoritative is enabled (see above), non-

authoritative methods are not attempted. See

for information about rearranging the position of the methods in the list.

9. Click Apply to save the configuration and apply the change.

Command line

1. Select the device in Remote Manager and click Actions > Open Console, or log into the

Connect IT 4 local command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. (Optional) Prevent other authentication methods from being used if RADIUS authentication

fails. Other authentication methods will only be used if the RADIUS server is unavailable.

(config)> auth radius authoritative true

4. (Optional) Enable debug messages from the RADIUS client:

(config)> auth radius debug true

5. (Optional) Configure the NAS ID. This is a unique identifier for this network access server (NAS).

You can use the fully-qualified domain name of the NAS or any arbitrary string. If not set, the

default value is used:

If you are accessing the Connect IT 4 device by using the WebUI, the default value is for

NAS ID is httpd.

If you are accessing the Connect IT 4 device by using ssh, the default value is sshd.

Digi Connect IT® 4 User Guide

Remote Authentication Dial-In User Service (RADIUS)

Rearrange the position of authentication