Example 2: Radius, Tacacs+, And Local Authentication For One User - Digi Connect IT 4 User Manual

User authentication
If admin > enable is set to false:
(config)> auth group admin acl admin enable true
(config)>
If admin > level is set to read-only:
(config)> auth group admin acl admin level full
(config)>
4. Verify that local is one of the configured authentication methods:
(config)> show auth method
0 local
(config)>
If local is not listed:
(config)> add auth method end local
(config)>
5. Create the user. In this example, the user is being created with the username adminuser:
(config)> add auth user adminuser
(config auth user adminuser)>
6. Assign a password to the user:
(config auth user adminuser)> password pwd
(config auth user adminuser)>
7. Assign the user to the admin group:
(config auth user adminuser)> add group end admin
(config auth user adminuser)>
8. Save the configuration and apply the change:
(config auth user adminuser)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Example 2: RADIUS, TACACS+, and local authentication for one user

Goal: To create a user with administrator rights who is authenticated by using all three authentication
methods.
In this example, when the user attempts to log in to the Connect IT 4 device, user authentication will
occur in the following order:
Digi Connect IT® 4 User Guide
Example user configuration
707