Digi Connect IT 4 User Manual page 368

Virtual Private Networks (VPN)

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a new SCEP client, for example, Fortinet_SCEP_client:
(config)> add network scep_client Fortinet_SCEP_client
(config network scep_client Fortinet_SCEP_client
)>
4. Enable the SCEP client:
(config network scep_client Fortinet_SCEP_client)> enable true
(config network scep_client Fortinet_SCEP_client)>
5. Set the url parameter to the fully qualified domain name or IP address of the SCEP server:
(config network scep_client Fortinet_SCEP_client)> server url
https://fortinet.example.com
(config network scep_client Fortinet_SCEP_client)>
6. Set the challenge password as configured on the SCEP server. This corresponds to the Default
enrollment password on the Fortinet server.
(config network scep_client Fortinet_SCEP_client)> server password
challenge_password
(config network scep_client Fortinet_SCEP_client)>
7. Set Distinguished Name attributes. The values entered here must correspond to the DN
attributes in the Enrollment Request on the Fortinet server.
a. Set the Domain Component:
(config network scep_client Fortinet_SCEP_client)> distinguished_name dc
value
(config network scep_client Fortinet_SCEP_client)>
b. Set the two letter Country Code:
(config network scep_client Fortinet_SCEP_client)> distinguished_name c
value
(config network scep_client Fortinet_SCEP_client)>
c. Set the State or Province:
Digi Connect IT® 4 User Guide
IPsec
368