Digi Connect IT 4 User Manual page 779

System administration
2. Enter the following:
> system factory-erase
3. After resetting the device:
a. Connect to the Connect IT 4 by using the serial port or by using an Ethernet cable to
connect the Connect IT 4 LAN port to your PC.
b. Log into the Connect IT 4:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
Note If your device was manufactured prior to the release of firmware version 19.11.x, the
default user name may be root.
c. (Optional) Reset the default password for the admin account. See
password for the admin user
Reset the device by using the ERASE button.
1. Locate the ERASE button on your device.
2. Press the ERASE button perform a device reset. The ERASE button has the following modes:
Configuration reset:
n
Press and hold the ERASE button for 5 seconds. While holding down the ERASE
l
button, the device will beep once per second. After 5 seconds, a constant beep will
sound. You can then release the ERASE button.
The device reboots automatically and resets to factory defaults. This does not
l
remove any automatically generated certificates and keys.
Full device reset:
n
After the device reboots from the first button press, immediately press and hold the
l
ERASE button for 5 seconds again. While holding down the ERASE button, the device
will beep once per second. After 5 seconds, a constant beep will sound. You can then
release the ERASE button.
The device reboots again and resets to factory defaults, as well as also removing
l
generated certificates and keys.
3. After resetting the device:
a. Connect to the Connect IT 4 by using the serial port or by using an Ethernet cable to
connect the Connect IT 4 LAN port to your PC.
b. Log into the Connect IT 4:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
Note If your device was manufactured prior to the release of firmware version 19.11.x, the
default user name may be root.
Digi Connect IT® 4 User Guide
Erase device configuration and reset to factory defaults
for further information.
Change the default
779