Verify Your Web Filtering Configuration - Digi Connect IT 4 User Manual

Hide thumbs Also See for Connect IT 4:

Table of Contents

7. (Optional) Repeat for additional DNS servers.

For example, to configure manual web-filtering using Cisco's open DNS servers:

a. Enable web filtering:

(config)> firewall web-filter enable true

b. Set the web filter service type to manual:

(config)> firewall web-filter service manual

c. Add the first DNS server:

i. Add the server:

(config)> add firewall web-filter server end

(config firewall web-filter server 0)>

ii. Set the server's IP address:

(config firewall web-filter server 0)> ip 208.67.222.220

(config firewall web-filter server 0)>

d. Add the second DNS server:

i. Move back one node in the configuration tree:

(config firewall web-filter server 0)> ..

(config firewall web-filter server)>

ii. Add the server:

(config firewall web-filter server)> add end

(config firewall web-filter server 1)>

iii. Set the server's IP address:

(config firewall web-filter server 1)> ip 208.67.222.222

(config firewall web-filter server 0)>

8. Save the configuration and apply the change:

(config)> save

Configuration saved.

9. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Verify your web filtering configuration

If your web filtering implementation has the service set to Cisco Umbrella, or if it is configured to use

manual DNS servers and uses the Cisco open DNS servers, you can verify the web filtering

implementation by using the Cisco test site www.internetbadguys.com.

Digi Connect IT® 4 User Guide

Web filtering