Digi Connect IT 4 User Manual page 113

Interfaces
iii. For Interface, select Interface: WWAN_Private.
6. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the maximum number of interfaces for the modem:
(config)> network modem modem max_intfs 2
(config)>
4. Create the WWAN interfaces:
a. Create the WWANPublic interface:
(config)> add network interface WWANPublic
(config network interface WWANPublic)>
b. Set the interface type to modem:
(config network interface WWANPublic)> type modem
(config network interface WWANPublic)>
c. Set the modem device:
(config network interface WWANPublic)> modem device modem
(config network interface WWANPublic)>
d. (Optional): Set the public APN. If the public APN is not configured, the Connect IT 4 will
attempt to determine the APN.
(config network interface WWANPublic)> modem apn public_apn
(config network interface WWANPublic)>
Digi Connect IT® 4 User Guide
Wide Area Networks (WANs)
113