Digi Connect IT 4 User Manual page 61

Interfaces
Execute custom Recovery commands.
l
Powercycle the modem. This recovery action is enabled by default for the preconfigured
l
WWAN interface.
Two options also apply to every type of action:
l
Attempts: The number of attempts for this recovery action to perform, before moving to
o
the next recovery action.
Override wait interval before performing the next recovery action: The time to wait
o
before the next test is run. If set to the default value of 0s, the Test interval is used.
Additional configuration items
The Test interval between connectivity tests.
n
If more than one tests is configured, determine whether the interface should fail over based on
n
the failure of one of the tests, or all of the tests.
The number of test that must pass before the interface is considered to be working and its
n
default route and DNS servers are reinstated.
The amount of time that the device should wait for a response from an individual test before
n
considering it to have failed.
Advanced configuration items:
n
Delayed Start: The amount of time to wait while the device is starting before SureLink
l
testing begins. This setting is bypassed when the interface is determined to be up.
Backoff interval: The time to add to the test interval when restarting the list of actions.
l
Test interface gateway by pinging: Used by the Interface gateway Ping test as the
l
endpoint for traceroute to use to determine the interface gateway.
Order of precedence for SureLink actions
SureLink recovery actions are preformed in the order that they are configured. As a result, if you
include the Reboot Device with other SureLink recovery actions, it should be the last action in the
recovery action list. Otherwise, the device will reboot and all recovery actions listed after the Reboot
Device action will be ignored.

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
Digi Connect IT® 4 User Guide
Use Digi Remote Manager to view and manage your
Wide Area Networks (WANs)
61