Digi Connect IT 4 User Manual page 794

System administration
4. If Central Management is disabled, configure the device to look for any updated device
firmware during the maintenance window. If updated firmware is found, it will then be
installed. The device will look for updated firmware both on the local device and over the
network, using either a WAN or cellular connection.
This options is only available if Central Management is disabled; see
more information.
(config)> system schedule maintenance device_fw_update true
(config)>
5. If Central Management is disabled, configure the device to look for any updated modem
firmware during the maintenance window. If updated firmware is found, it will then be
installed. The device will look for updated firmware both on the local device and over the
network, using either a WAN or cellular connection.
This options is only available if Central Management is disabled; see
more information.
(config)> system schedule maintenance modem_fw_update true
(config)>
6. (Optional) Configure automated checking for device firmware updates:
a. Device firmware update check is enabled by default. This enables to automated checking
for device firmware updates. To disable:
(config)> system schedule maintenance firmware_update_check device false
(config)>
Digi Connect IT® 4 User Guide
If the duration length is set to any value other than to 0 or 24 hours, the
l
maintenance tasks will run at a random time during the time allotted for
the duration window.
If the duration length is set to one or more hours, the minutes field in the
l
start time is ignored and the duration window will begin at the beginning of
the specified hour.
ii. Configure the duration length (the amount of time that the maintenance tasks
will be run). If 0 is used, all scheduled tasks will begin at the start time, defined
in the previous step.
(config system schedule maintenance trigger 0)> length num
(config system schedule maintenance trigger 0)>
where num is any whole number between 0 and 24.
iii. Configure the frequency that the maintenance tasks should be run:
(config system schedule maintenance trigger 0)> frequency
value
(config system schedule maintenance trigger 0)>
where value is either daily or weekly. Daily is the default.
Schedule system maintenance tasks
Central management
Central management
for
for
794