Digi Connect IT 4 User Manual page 161

Interfaces
f. Click Add Device  again and select the Device: LAN.
Note If you are adding a port or access point that is already part of the default LAN1
bridge, you should either disable the default bridge, or remove the port or access point:
i. Click Network > Bridges > LAN1.
4. Create a LAN interface for the bridge:
a. Click Network > Interfaces.
b. For Add Interface, type a name for the interface and click .
c. For Zone, select Internal.
d. For Device, select the new bridge.
e. Click to expand IPv4.
f. For Address, type the IPv4 address and netmask, using the format IPv4_address/netmask,
for example, 192.168.3.1/24.
g. Enable the DHCP server:
i. Click to expand DHCP server.
ii. Click to toggle on Enable.
Digi Connect IT® 4 User Guide
To disable the bridge, click to toggle off Enable.
n
To remove a port or access point from the bridge:
n
i. Click to expand Devices.
ii. Click  next to a device.
iii. Select  Delete.
Local Area Networks (LANs)
161