Interfaces
Show SureLink State
To show the current state of SureLink for the Connect IT 4 device, use the
command:
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type:
> show surelink state
Test on network.interface.wan.ipv6 with condition: one
dns_configured (n);
network.interface.wan.ipv6;
ACTION
restart_interface
update_routing_table 00/01
Test on network.interface.modem.ipv4 with condition: all
dns_configured (n);
network.interface.modem.ipv4;
ACTION
update_routing_table 00/03
restart_interface
reset_modem
switch_sim
modem_power_cycle
restart_interface
>
Show SureLink status for all interfaces
To show the SureLink status all interfaces, use the
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type :
> show surelink interface all
Interface
---------
wan
wan
Digi Connect IT® 4 User Guide
-> update_routing_table
ATTEMPTS
00/01
-> restart_interface
ATTEMPTS
00/03
00/03
00/03
00/03
00/03
Test
-----------------------------
Interface is up
Interface's DNS servers (DNS)
Show SureLink status and statistics
show surelink state
STATUS
[FAILED]
STATUS
[ BUSY ]
show surelink interface all
Proto
Last Response
-----
-------------
IPv4
32 seconds
IPv4
28 seconds
command:
Status
-------
Passing
Passing
204