Table of Contents
Advertisement
File system
The Connect IT 4 local file system
The Connect IT 4 local file system has approximately 30 MB of space available for storing files, such as
alternative configuration files and firmware versions, and release files, such as cellular module
images. The writable directories within the filesystem are:
/tmp
n
/opt
n
/etc/config
n
Files stored in the /tmp directory do not persist across reboots. Therefore, /tmp is a good location to
upload temporary files, such as files used for firmware updates. Files stored in /opt and /etc/config do
persist across reboots, but are deleted if a factory reset of the system is performed. See
configuration and reset to factory defaults
Display directory contents
To display directory contents by using the WebUI or the Admin CLI:
Web
1. Log into the Connect IT 4 WebUI as a user with Admin access.
2. On the menu, click System. Under Administration, click File System.
The File System page appears.
3. Highlight a directory and click to open the directory and view the files in the directory.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
Digi Connect IT® 4 User Guide
for more information.
The Connect IT 4 local file system
Erase device
839
Advertisement
Table of Contents
