Wide Area Networks (Wans) - Digi Connect IT 4 User Manual

Interfaces

Wide Area Networks (WANs)

The Connect IT 4 device is preconfigured with one Wide Area Network (WAN), named WAN, and one
Wireless Wide Area Network (WWAN), named Modem.
You can modify configuration settings for the existing WAN and WWANs, and you can create new WANs
and WWANs.
This section contains the following topics:
Wide Area Networks (WANs) and Wireless Wide Area Networks (WWANs)
Configure WAN/WWAN priority and default route metrics
WAN/WWAN failover
Configure SureLink active recovery to detect WAN/WWAN failures
Configure the device to reboot when a failure is detected
Disable SureLink
Example: Use a ping test for WAN failover from Ethernet to cellular
Using Ethernet devices in a WAN
Using cellular modems in a Wireless WAN (WWAN)
Configure a Wide Area Network (WAN)
Configure a Wireless Wide Area Network (WWAN)
Show WAN and WWAN status and statistics
Delete a WAN or WWAN
Default outbound WAN/WWAN ports
Digi Connect IT® 4 User Guide
Wide Area Networks (WANs)
56
56
59
60
77
90
99
101
102
125
133
143
145
146
55