Digi Connect IT 4 User Manual page 524

Services
id: Reports the vehicle ID.
l
ln: Long navigation: reports the latitude, longitude, and altitude, the horizontal and
l
vertical speed, and heading.
pv: Position/velocity: reports the latitude, longitude, and heading.
l
To remove a message type:
a. Use the show command to determine the index number of the message type to be
b. Use the index number to delete the message type. For example, to delete the id
To add a message type:
a. Change to the filter_taip node:
b. Use the add command to add the message type. For example, to add the id
13. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
14. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Digi Connect IT® 4 User Guide
deleted:
(config service location forward 0)> show filter_taip
0 al
1 cp
2 id
3 ln
4 pv
(config service location forward 0)>
(index number 2) message type:
(config service location forward 0)> del filter_taip 2
(config service location forward 0)>
(config service location forward 0)> filter_taip
(config service location forward 0 filter_taip)>
message type:
(config service location forward 0 filter_taip)> add id end
(config service location forward 0 filter_taip)>
Location information
524