Digi Connect IT 4 User Manual page 93

Interfaces
5. After selecting the WAN or WWAN, click SureLink.
6. Click to expand Tests.
7. Click to expand the default DNS configured test.
8. Click to toggle off Enable.
9. Click  to add a new test.
10. Type a Label for the test.
11. Click to toggle on IPv6 if the test should apply to both IPv6 rather than IPv4.
12. Select the Test type.
Available test types:
Ping test: Uses ICMP to determine connectivity.
n
If Ping test is selected, complete the following:
Ping target: The type of target for the ping, one of:
l
o
o
o
o
Ping payload size: The number of bytes to send as part of the ping payload.
l
DNS test: Performs a DNS query to the named DNS server.
n
If DNS test is selected, complete the following:
DNS server: The IP address of the DNS server.
l
Digi Connect IT® 4 User Guide
Hostname or IP address of an external server.
Ping host: hostname or IP address of the server.
o
The Interface gateway. If Interface gateway is selected, an initial traceroute is
sent to the hostname or IP address configured in the SureLink advanced settings,
and then the first hop in that route is used for the ping test.
The Interface address.
The Interface DNS server.
Wide Area Networks (WANs)
93