Erase Device Configuration And Reset To Factory Defaults - Digi Connect IT 4 User Manual

System administration
4. Set the maximum random delay that will be added to reboot_time:
(config>> system schedule reboot_window value
(config)>
where value is any number of hours, minutes, or seconds, and takes the format number{h|m|s}.
For example, to set reboot_window to ten minutes, enter either 10m or 600s:
(config)> system schedule reboot_window 600s
(config)>
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Erase device configuration and reset to factory defaults

You can erase the device configuration in the WebUI, at the command line, or by using the ERASE
button on the device. Erasing the device configuration performs the following actions:
Clears all configuration settings. When the device restarts, it uses the factory default
n
configuration.
Deletes all user files.
n
Clears event and system log files.
n
Additionally, if the ERASE button is used to erase the configuration, pressing the ERASE button a
second time immediately after the device has rebooted:
Erases all automatically generated certificates and keys.
n
With firmware release 22.2.9.x and newer, erases the client-side certificate used for
n
communication with Digi Remote Manager.
If you are using Digi Remote Manager with firmware release 22.2.9.x and newer, by default the
device uses a client-side certificate for communication with Remote Manager. If the client-side
certificate is erased, you must use the Remote Manager interface to reset the certificate.
If your device uses a
n
the device will reboot using standard factory default settings.
You can also reset the device to the default configuration without removing scripts, keys, and logfiles
by using the revert command.

Web
Digi Connect IT® 4 User Guide
Erase device configuration and reset to factory defaults
custom factory default, the custom factory default will be removed and
777