Digi Connect IT 4 User Manual page 200

Interfaces
Note The MAC address of the bridge is taken from the first available device in the list.
a. To delete a device from the bridge:
i. Determine the index numbers of the devices included with the bridge:
(config)> show network bridge lan device
0 /network/device/eth2
1 /network/wireless/ap/digi_ap
(config)>
ii. Use the index number to delete the appropriate device. For example, to delete the
Digi AP (Wi-Fi1) Wi-Fi access point from the bridge:
(config)> del network bridge lan device
(config)>
Note
reordered after each deletion. As a result, best practice is to perform a show network
bridge lan1 device command after each device is deleted to determine the new
index numbering.
b. Add devices to the bridge:
i. Determine available devices:
(config network bridge my_bridge)> .. .. interface lan device ?
Default value: /network/bridge/lan
Current value: /network/bridge/lan
(config network bridge my_bridge)>
ii. Add the appropriate device.
5. (Optional) Enable Spanning Tree Protocol (STP).
STP is used when multiple LANs are configured on the same device, to prevent bridge loops and
other routing conflicts.
a. Enable STP:
(config)> network bridge lan stp enable true
b. Set the number of seconds that the device will spend in each of the listening and learning
states before the bridge begins forwarding data:
(config)> network bridge lan stp forward_delay num
(config)>
The default is 2 seconds.
Digi Connect IT® 4 User Guide
If you are deleting multiple devices from the bridge, the device index may be
Bridging
200