Digi Connect IT 4 User Manual page 300

Hide thumbs Also See for Connect IT 4:

Table of Contents

6. For Ping host, type https://remotemanager.digi.com.

Task 5: Configure the DHCP server for LAN on device two

1. Click to expand Network > Interfaces > LAN > IPv4 > DHCP Server

2. For Lease range start, type 200.

3. For Lease range end, type 250.

4. Click Advanced settings.

5. For Gateway, select Custom.

6. For Custom gateway, enter 192.168.3.3.

7. Click Apply to save the configuration and apply the change.

Command line

Task 1: Configure VRRP on device two

1. Select the device in Remote Manager and click Actions > Open Console, or log into the

Connect IT 4 local command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

Digi Connect IT® 4 User Guide

Virtual Router Redundancy Protocol (VRRP)