Digi Connect IT 4 User Manual page 289

Routing
11. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new VRRP instance, or edit an existing one. See
about creating a new VRRP instance.
4. Enable VRRP+:
(config)> network vrrp VRRP_test vrrp_plus enable true
(config)>
5. Add interfaces to monitor. Generally, this will be a cellular or WAN interface.
a. Use the ? to determine available interfaces:
(config)> network vrrp test interface ?
Interface: The network interface.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config)> network vrrp test interface
Digi Connect IT® 4 User Guide
Virtual Router Redundancy Protocol (VRRP)
Configure VRRP for information
289