Digi Connect IT 4 User Manual page 265

Routing
10. For DSCP, type the 6-bit hexadecimal Differentiated Services Code Point (DSCP) field match
criteria. This will match packets based on the DHCP field within the ToS field of the IP header.
11. Configure source address information:
a. Click to expand Source address.
b. For Type, select one of the following:
n
n
n
n
n
12. Configure the destination address information:
a. Click to expand Destination address.
b. For Type, select one of the following:
n
n
n
n
n
n
13. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Digi Connect IT® 4 User Guide
Zone: Matches the source IP address to the selected firewall zone. See
configuration for more information about firewall zones.
Interface: Matches the source IP address to the selected interface's network
address.
IPv4 address: Matches the source IP address to the specified IP address or
network. Use the format IPv4_address[/netmask], or use any to match any IPv4
address.
IPv6 address: Matches the source IP address to the specified IP address or
network. Use the format IPv6_address[/prefix_length], or use any to match any
IPv6 address.
MAC address: Matches the source MAC address to the specified MAC address.
Zone: Matches the destination IP address to the selected firewall zone. See
Firewall configuration for more information about firewall zones.
Interface: Matches the destination IP address to the selected interface's network
address.
IPv4 address: Matches the destination IP address to the specified IP address or
network. Use the format IPv4_address/[netmask], or use any to match any IPv4
address.
IPv6 address: Matches the destination IP address to the specified IP address or
network. Use the format IPv6_address/[prefix_length], or use any to match any IPv6
address.
Domain: Matches the destination IP address to the specified domain names. To
specify domains:
i. Click to expand Domains.
ii. Click the  to add a domain.
iii. For Domain, type the domain name.
iv. Repeat to add additional domains.
Default route: Matches packets destined for the default route, excluding routes for
local networks.
IP routing
Firewall
265