Serial port
7. Set the number of data bits used by the device to which you want to connect:
(config)>serial port1 databits bits
(config)>
8. Set the type of parity used by the device to which you want to connect:
(config)>serial port1 parity parity
(config)>
Allowed values are:
even
n
odd
n
none
n
The default is none.
9. Set the stop bits used by the device to which you want to connect:
(config)>serial port1 stopbits bits
(config)>
10. Set the type of flow control used by the device to which you want to connect:
(config)>serial port1 flow value
(config)>
where value is one of:
none
n
rts/cts
n
xon/xoff
n
11. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure PPP dial-in mode
PPP dial-in allows the device to answer Point-to-Point Protocol (PPP) connections over serial ports.
To change the configuration to match the serial configuration of the device to which you want to
connect:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
Digi Connect IT® 4 User Guide
Configure PPP dial-in mode
231