Digi Connect IT 4 User Manual page 663

User authentication
Set the access level for Admin access:
n
(config)> auth group admin acl admin level value
(config)>
where value is either:
full: provides users of this group with the ability to manage the Connect IT 4 device
l
by using the WebUI or the Admin CLI.
read-only: provides users of this group with read-only access to the WebUI and
l
Admin CLI.
The default is full.
Shell access:
n
(config auth group test)> acl shell enable true
(config)>
Shell access is not available if the Allow shell parameter has been disabled. See
shell access
Serial access:
n
(config auth group test)> acl serial enable true
(config)>
5. (Optional) Configure the serial ports to which users of the group have access.
(config auth group test)> acl serial add ports end port1
(config auth group test)>
6. (Optional) Configure captive portal access:
a. Return to the config prompt by typing three periods (...):
(config auth group test)> ...
(config)>
b. Enable captive portal access rights for users of this group:
(config)> auth group test acl portal enable true
(config)>
c. Add a captive portal to which users of this group will have access:
i. Determine available portals:
(config)> show firewall portal
portal1
Digi Connect IT® 4 User Guide
for more information about the Allow shell parameter.
auth none
enable true
http redirect
no interface
no message
no redirect_url
no terms
Authentication groups
Disable
663