Digi Connect IT 4 User Manual page 869

Hide thumbs Also See for Connect IT 4:

Table of Contents

c. To create a filter that either captures or ignores packets that use a particular IP protocol:

i. Click to expand Filter IP protocols.

ii. Click  to add an IP protocol.

iii. For IP protocol to capture or ignore, select the protocol. If Other protocol is

selected, type the number of the protocol.

iv. Click Ignore this protocol if the filter should ignore packets that use this protocol. By

default, is option is disabled, which means that the filter will capture packets that use

this protocol.

v. Click  to add additional IP protocols filters.

d. To create a filter that either captures or ignores packets from a particular port:

i. Click to expand Filter TCP/UDP port.

ii. Click  to add a TCP /UDP port.

iii. For IP TCP/UDP port to capture or ignore, type the number of the port to be

captured or ingored.

iv. For TCP or UDP port, select the type of transport protocol.

v. For Source or destination TCP/UDP port, select whether the filter should apply to

packets when the port is the source, the destination, or both.

vi. Click Ignore this TCP/UDP port if the filter should ignore packets that use this port.

By default, is option is disabled, which means that the filter will capture packets that

use this port.

vii. Click  to add additional port filters.

e. To create a filter that either captures or ignores packets from one or more specified MAC

i. Click to expand Filter Ethernet MAC addresses.

ii. Click  to add a MAC address.

iii. For Ethernet MAC address, type the MAC address to be captured or ingored.

iv. For Source or destination Ethernet MAC address, select whether the filter should

apply to packets when the Ethernet MAC address is the source, the destination, or

v. Click Ignore this MAC address if the filter should ignore packets that use this port. By

default, is option is disabled, which means that the filter will capture packets that use

vi. Click  to add additional MAC address filters.

f. To create a filter that either captures or ignores packets from one or more VLANs:

i. Click to expand Filter VLANs.

ii. Click  to add a VLAN.

iii. For The VLAN to capture or ignore, type the number of the VLAN.

iv. Click Ignore this VLAN if the filter should ignore packets that use this port. By default,

is option is disabled, which means that the filter will capture packets that use this

v. Click  to add additional VLAN filters.

Digi Connect IT® 4 User Guide

Analyze network traffic