Table of Contents
Advertisement
Routing
9. Set the source address type:
(config network route policy 0)> src type value
(config network route policy 0)>
where value is one of:
zone: Matches the source IP address to the selected firewall zone. Set the zone:
n
a. Use the ? to determine available zones:
b. Set the zone. For example:
See
interface: Matches the source IP address to the selected interface's network address.
n
Set the interface:
a. Use the ? to determine available interfaces:
Digi Connect IT® 4 User Guide
(config network route policy 0)> src zone ?
Zone: Match the IP address to the specified firewall zone.
Format:
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
Default value: any
Current value: any
(config network route policy 0)> src zone
(config network route policy 0)> src zone external
(config network route policy 0)>
Firewall configuration
for more information about firewall zones.
(config network route policy 0)> src interface ?
Interface: The network interface.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config network route policy 0)> src interface
IP routing
268
Advertisement
Table of Contents
