Digi Connect IT 4 User Manual page 170

Interfaces
For example, to set Lease time to ten minutes, enter 10m or 600s.
The default is 12 hours.
By default, DHCP leases are persistent across reboots. You can disable persistent
n
leases:
a. Click Network > Advanced.
b. Click to toggle off DHCP persistent leases.
8. (Optional) For Lease range start and Lease range end, type the lowest and highest IP
address that the DHCP server will assign to a client. This value represents the low order byte
of the address (the final triplet in an IPv4 address, for example, 192.168.2.xxx). The remainder
of the IP address will be based on the LAN's static IP address as defined in the Address field.
Allowed values are between 1 and 254, and the default is 100 for Lease range start and 250
for Lease range end.
Sequential DHCP address allocation:
n
By default, DHCP addresses are assigned psuedo-randomly, using a hash of the client's
MAC address to determine the IP address that gets assigned. You can configure the
device to use sequential IP addresses instead:
a. Click Network > Advanced.
b. Click to enable Sequential DHCP address allocation.
Because sequential mode does not use a hash based on the client's MAC address, when
DHCP lease expires, the client is not likely to get the same IP address assigned to it.
Therefore, sentential DHCP address allocation generally should not be used.
9. Optional DHCP server settings:
a. Click to expand Advanced settings.
b. For Gateway, select either:
n
n
n
The default is Automatic.
c. For MTU,
n
n
n
The default is Automatic.
d. For Domain name suffix, type the domain name that should be appended to host names.
e. For Primary and Secondary DNS, Primary and Secondary NTP server, and Primary and
Secondary WINS server, select either:
n
n
n
f. For Bootfile name, type the relative path and file name of the bootfile on the TFTP server.
Digi Connect IT® 4 User Guide
None: No gateway is broadcast by the DHCP server. Client destinations must be
resolvable without a gateway.
Automatic: Broadcasts the Connect IT 4 device's gateway.
Custom: Allows you to identify the IP address of a Custom gateway to be
broadcast.
None: An MTU of length 0 is broadcast. This is not recommended.
Automatic: No MTU is broadcast and clients will determine their own MTU.
Custom: Allows you to identify a Custom MTU to be broadcast.
None: No server is broadcast.
Automatic: Broadcasts the Connect IT 4 device's server.
Custom: Allows you to identify the IP address of the server.
Local Area Networks (LANs)
170