Digi Connect IT 4 User Manual page 33

Firmware configuration
To determine allowed values for path from the Admin CLI:
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access
selection menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, type ? (question mark):
(config)> ?
auth
cloud
firewall
monitoring
network
serial
service
system
vpn
(config)>
The allowed values for path are listed in the first (left) column.
4. To determine further allowed path location values by using the ? (question mark) with
the path name:
(config> service ?
Services
Additional Configuration
---------------------------------------------------------------------
----------
dns
iperf
location
mdns
modbus_gateway
multicast
ntp
ping
snmp
ssh
telnet
web_admin
(config)> service
For example, to use curl to return the ssh configuration:
Digi Connect IT® 4 User Guide
Use the local REST API to configure the Connect IT 4 device
Authentication
Central management
Firewall
Monitoring
Network
Serial
Services
System
VPN
DNS
IPerf
Location
Service Discovery (mDNS)
Modbus Gateway
Multicast
NTP
Ping responder
SNMP
SSH
Telnet
Web administration
33