Show Network; Device Configuration Using The Command Line Interface; Execute Configuration Commands At The Root Admin Cli Prompt - Digi Connect IT 4 User Manual

Hide thumbs Also See for Connect IT 4:

Table of Contents

Command line interface

show network

show network

> show network

----------------

defaultlinklocal

The config command allows for device configuration from the command line. All configuration tasks

that can be performed by using the WebUI can also be performed by using the config command.

There are two ways to invoke the config command from the CLI:

Execute the config command and parameters at the root prompt. See

commands at the root Admin CLI prompt

Enter configuration mode by executing the config command without any parameters. See

Configuration mode

You can execute the config command at the root Admin CLI prompt with any appropriate parameters.

When the config command is used in this way, changes to the device's configuration are automatically

saved when the command is executed.

For example, to disable the SSH service from the root prompt, enter the following command:

> config service ssh enable false

The Connect IT 4 device's ssh service is now disabled.

When the config command is executed at the root prompt, certain configuration actions that

are available in configuration mode cannot be performed. This includes validating configuration

changes, canceling and reverting configuration changes, and performing actions on elements in lists.

Configuration mode

Digi Connect IT® 4 User Guide

command displays status and statistics for network interfaces.

-------------------------------

192.168.210.1/24

169.254.100.100/16

0:0:0:0:0:ffff:c0a8:301

192.168.3.1/24

fd00:2704::240:ffff:fe80:120/64

for more information.

for information about using configuration mode.

Device configuration using the command line interface

for more information.

Execute configuration