Digi Connect IT 4 User Manual page 87

Interfaces
f. Repeat for each additional test.
Digi Connect IT® 4 User Guide
Set the interface to test.
l
i. Use the ? to determine available interfaces:
(config network interface my_wan surelink tests 1)> other_
interface ?
Test interface: Test the status of this other interface.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config network interface my_wan surelink tests 1)> other_
interface
ii. Set the interface. For example:
(config network interface my_wan surelink tests 1)> other_
interface /network/interface/wan
(config network interface my_wan surelink tests 1)>
Set the type of IP connection:
l
(config network interface my_wan surelink tests 1)> other_ip_
version value
(config network interface my_wan surelink tests 1)>
where value is one of:
any: Either the IPv4 or IPv6 connection must be up.
o
both: Both the IPv4 or IPv6 connection must be up.
o
ipv4 The IPv4 connection must be up.
o
ipv6: The IPv6 connection must be up.
o
The status required for the test to past.
l
(config network interface my_wan surelink tests 1)> other_
status value
(config network interface my_wan surelink tests 1)>
where value is one of:
up: The test will pass only if the referenced interface is up and passing its
o
own SureLink tests (if applicable).
down: The test will pass only if the referenced interface is down or failing its
o
own SureLink tests (if applicable).
Wide Area Networks (WANs)
87