Digi Connect IT 4 User Manual page 71

Interfaces
f. Repeat for each additional test.
6. Add recovery actions:
a. Type ... to return to the root of the configuration:
(config network interface my_wan surelink tests 1)> ...
(config)>
b. Add a recovery action:
(config)> add network interface my_wan surelink actions end
(config network interface my_wan surelink actions 0)>
c. New actions are enabled by default. To disable:
(config network interface my_wan surelink actions 0)> enable false
(config network interface my_wan surelink actions 0)>
d. Create a label for the action:
(config network interface my_wan surelink actions 0)> label string
(config network interface my_wan surelink actions 0)>
e. Set the type of recovery action. If multiple recovery actions are configured, they are
performed in the order that they are listed. The command varies depending on whether
the interface is a WAN or WWAN:
Digi Connect IT® 4 User Guide
Set the type of IP connection:
l
(config network interface my_wan surelink tests 1)> other_ip_
version value
(config network interface my_wan surelink tests 1)>
where value is one of:
any: Either the IPv4 or IPv6 connection must be up.
o
both: Both the IPv4 or IPv6 connection must be up.
o
ipv4 The IPv4 connection must be up.
o
ipv6: The IPv6 connection must be up.
o
The status required for the test to past.
l
(config network interface my_wan surelink tests 1)> other_
status value
(config network interface my_wan surelink tests 1)>
where value is one of:
up: The test will pass only if the referenced interface is up and passing its
o
own SureLink tests (if applicable).
down: The test will pass only if the referenced interface is down or failing its
o
own SureLink tests (if applicable).
Wide Area Networks (WANs)
71