Digi Connect IT 4 User Manual page 793

System administration
n
n
n
Digi Connect IT® 4 User Guide
interface_up: If interface_up is set:
i. Set the interface:
(config add system schedule maintenance trigger)> interface
value
(config)>
ii. i. Use the ? to determine available interfaces:
(config system schedule maintenance trigger 0)> interface ?
Test interface: Test the status of this interface to see if
it is up.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config system schedule maintenance trigger 0)> interface
ii. Set the interface. For example:
(config system schedule maintenance trigger 0)> interface
/network/interface/wan
(config system schedule maintenance trigger 0)>
out_of_service: The maintenance window will only start if the Python Out-of-
Service is set. See Use Python to set the maintenance window
information.
time: Configure a time period for the maintenance window:
i. Configure the time of day that the maintenance window should start, using the
syntax HH:MM. If the start time is not set, maintenance tasks are not scheduled
and will not be run.
(config system schedule maintenance trigger 0)> time from
HH:MM
(config system schedule maintenance trigger 0)>
The behavior of the start time varies depending on the setting of the duration
length, which is configured in the next step.
If the duration length is set to 0, all scheduled tasks will begin at the exact
l
time specified in the start time.
If the duration length is set to 24 hours, the start time is effectively
l
obsolete and the maintenance tasks will be scheduled to run at any time.
Setting the duration length to 24 hours can potentially overstress the
device and should be used with caution.
Schedule system maintenance tasks
for further
793