Delta ASDA-A3 Series User Manual page 1242

ASDA-A3
Item
Protection function
Communication interface
Installation site
Altitude
Atmospheric pressure
Operating temperature
Storage temperature
Humidity
Vibrating
IP rating
Power system
Approvals
Note:
1. Within the rated load, the speed ratio is: the minimum speed (smooth operation) / rated speed.
2. Within the rated speed, the speed calibration ratio is: (rotational speed with no load - rotational speed
with full load) / rated speed.
3. TN system: the neutral point of the power system connects directly to the ground. The exposed metal
components connect to the ground through the protective ground conductor.
4. Use a single-phase three-wire power system for the single-phase power model.
Overcurrent, Overvoltage, Undervoltage, Overheat, Regeneration
error, Overload, Excessive speed deviation, Excessive position
deviation, Encoder error, Calibration error, Emergency stop,
Positive / negative limit error, Serial communication error, RST power
error, Serial communication timeout, Short-circuit protection for
terminals U, V, W.
RS-485 / USB / CANopen / DMCNET / EtherCAT
Indoors (avoid direct sunlight),
no corrosive vapor (avoid fumes, flammable gases, and dust)
Less than 2,000 m above sea level
86 kPa - 106 kPa
0˚C to 55˚C (32˚F to 131˚F)
(If the operating temperature is above 45˚C (113˚F),
forced cooling is required)
-20˚C to +65˚C (14˚F to 176˚F)
Under 0 - 90% RH (non-condensing)
10 Hz - 57 Hz: 0.075 mm amplitude; 58 Hz - 150 Hz: 1G
IEC/EN/UL 61800-5-1
Specification
IP20
*3*4
TN system
Specifications
A
A-5