Manitou MRT-X 2470 Privilege Plus ST3A S1 Operator's Manual page 305

- Move the rotating telehandler to the opposite side of the fork and align it with others (
- carefully and slowly move the arm towards the plates to couple the fork carriage, positioning
the machine attachment accurately on the short tubes of the plates (16,
- slowly tilt the machine attachment backwards to couple the short tubes (16,

the plates (17, 30) being careful to not lift the forks from the ground to prevent collisions
between the machine head and the grid on the fork carriage (if installed),

- insert the spear (18, 30) hold the forks on the ground.
Load the ballast on the TFF fork carriage
Once the fork carriage has been configured, add the Manitou ballast (type 52584283) (34,
onto the rotating telehandler, on the front part and proceed as follows:

29),

30),

30) onto

31)
33
16 16
17
17
29
18
18
30
34
31
EN