Wacom Cintiq Pro 32 Manual page 87

Parameter
Pool Name to
Select
Port
Auto Connect
Auto Launch If
Only One Pool
Use OSD Logo for
Login Banner
Enable Peer Loss
Overlay
© 2020 Teradici
OSD: View Connection Server + Auto-Logon Session Settings
Description
Enter the pool name. When the list includes a pool with this name, the client will immediately
start a session with that pool.
This field is case-insensitive. For Tera1 PCoIP Zero Clients, this parameter is called Desktop
Name to Select.
By default, port 443 is used to communicate with the connection server. If your network is set
up to use a non-standard port for secure connections, enter the port number.
This field determines the client's auto connect behavior after startup:
Enabled: The client automatically connects with the connection server after startup and a
PCoIP session ends, bypassing the OSD Connect page.
Disabled: The client does not automatically connect with the connection server.
Enabled With Retry On Error: The client will continuously attempt to contact the connection
server. After a connection failure, the client waits before attempting to connect again. This
wait time increases with each successive failure. The wait interval is not configurable.
Devices running firmware 4.1.1 or lower do not support Retry On Error behavior and will
always perform a single attempt to contact the connection server when this option is
selected.
After enabling Auto Connect, the client must be power-cycled for the change to take effect.
When enabled, users are automatically connected to a provisioned desktop or application
after user credentials are entered.
For Tera1 PCoIP Zero Clients, this parameter is called Auto Launch If Only One Desktop.
This feature only applies to users who are entitled to a single desktop. It does not apply to
users entitled to multiple virtual desktops.
When enabled, the OSD logo banner appears at the top of login screens in place of the default
banner.
When enabled, the 'Network Connection Lost' overlay appears on the display(s) when a loss
of network connectivity is detected. Normal hypervisor scheduling delays can falsely trigger
this message.
87