Table of Contents
Advertisement
Assigning an IP Address to a Tera2 PCoIP Zero
Client
When a Tera2 PCoIP Zero Client is powered on for the first time, you can display its IP address by
logging into the OSD and selecting Options > Configuration > Network.
If you want, you can manually change the IP address either dynamically or statically.
Assigning the IP Address Dynamically
If your network supports DHCP and your Tera2 PCoIP Zero Client is enabled for DHCP, the Tera2
PCoIP Zero Client will automatically receive an IP address from your DHCP server when it's first
powered on. One advantage to dynamic IP address assignment is that you can deploy multiple
Tera2 PCoIP Zero Clients simultaneously in your network.
The Tera2 PCoIP Zero Client may receive a different IP address when it's powered off
• If the client is subsequently powered off for a period of time that exceeds its DHCP lease time, the client may
receive a different IP address when it's powered on again. You can avoid this issue by using a DHCP reservation
to permanently associate the IP address received from the DHCP server with the device.
• As well, if there is no available DHCP server when the zero client powers on, after 4 attempts the zero client will
use it's fall back IP address. Only a power reset will initiate a DHCP request at this point.
Assigning the IP Address Statically
If your network doesn't support DHCP, the Tera2 PCoIP Zero Client will use its static fallback IP
address the first time it's powered on. This address is set by the device's manufacturer.
You can statically assign an IP address from the Tera2 PCoIP Zero Client's OSD Network page.
Because all Tera2 PCoIP Zero Clients from the same manufacturer will have the same default IP
address, you can only deploy a single client at a time when you assign IP addresses statically.
© 2020 Teradici
Assigning an IP Address to a Tera2 PCoIP Zero Client
216
Advertisement
Table of Contents
